In Footnote 4, it mentions that "current for brownout, high side supervisor (SVSH) normal mode is included" inferring that SVSHE is kept at one here. Looking at the Backup Subsystem section on page 26 in the datasheet , it says that "it is necessary to keep the high side SVS enabled ... to turn off the low-frequency oscillator (XT1) in LPM4". Perhaps, this is the reason. Regarding EnergyTrace , you can launch it independently of a debug session in CCS to measure LPM4 current with the MSP-FET . Regards, James MSP Customer Applications
↧
