Hello, guys. I have a circuit based on a MSP430F5232 and I am trying to program/debug it drawing the MSP-EXP430F5529 board that we already had using the part eZ430-EMULATION [image attached]. We are using the platform CCS v6 , and the firmware is a simple LED BLINK. We used this sort of programming with CC430F5137 without any problem, but with the microcontroller MSP430F5232 it always appears the message " Could not find device (or device not supported) ". The lines connected between MSP430F5232 and the eZ430 Target connector are: VCC , GND , RSTDVCC/SBWTDIO and TEST/SBWTCK . I have used the Vcc of the ez430-emulation without powering the PCB and the own Vcc of the PCB, disconnecting the line VCC with ez. But in both cases it didn't program. Could it be the RST/NMI pin the problem. I just connected it to a pullup resistor (47K)? The line RSTDVV/SBWTDIO has a pullup resistor of 47K: could it be the problem? What am I doing wrong? Thanks in advance! Best regards, Luis
↧