Hello, I have three (3) MSP-EXP430F5529LP LaunchPads that I have upgraded the onboard USB Debug Interface tool firmware using the SmartRF Flash programmer when prompted by the following message . Launchpad #1 updated successfully and I am now able to flash HEX files via SmartRF normally. Launchpad #2 became unresponsive ( LaunchPad does not show up under Ports (COM & LPT) sub-section in Device Manager ) after receiving the following error upon completion of the firmware update procedure. Is it possible to recover the LaunchPad from this bricked state? LaunchPad #3 shows up as a COM port in Device Manager, however the LaunchPad is constantly being enumerated via USB when the SmartRF Flash programmer utility ( i.e. constant pop-ups showing that a new device has been connected/disconnected, this continues indefinitely until the LaunchPad is disconnected from the PC). I have this same problem on both my Windows 10 (64-bit) and Windows 7 (64-bit) machine . Is there a fix for this behavior? My system info: OS: W10 (64-bit), W7 (64-bit) SmartRF Flash programmer: v1.12.8 Launchpad Hardware Revision: v1.6 (for all three units)
↧