Hi, I managed to setup KEIL's IDE and have some good and some bad news. Good news first, KEIL is flashing Rev 2.0 ( and Rev 1.0). Bad news is, that some firmwares that run in the Rev 1.0 do not run in Rev 2.0. I flashed some firmwares i been playing these days for my final course project that i garantee tha runs smoothly in Rev 1.0. I that it has something to do with DCO calibration because initially i flashed a firmware that doesn't change clock calibration and it run ok, then i flashed a program that comunicates over uart and for that i change SMCLK to 12MHz and the firmware doesn't do what's expected ( at that point i tried flash Rev 2.0 and it worked fine ). Tomorrow i will look more carefully into this and try to setup IAR's IDE.
↧