Caleb, Thank you for your reply. - - - > could you try programming with the standard blinky found in MSP430Ware and let me know the results? This case, one more line was displayed. MSP430: Trouble Writing Memory Block at 0x4000 on Page 0 of Length 0x20: Could not erase device memory MSP430: File Loader: Verification failed: Target failed to write 0x04000 MSP430: GEL: File: \Debug\test.out: Load failed. - - - > More specifically, how are the AUX power connections setup? My customer observed the AUXVCC-{1:3} by oscilloscope but none of drops/dips were found. - - - > The main things we need to check hardware-wise are the JTAG and power connections. If you could provide a schematic with these visible that would be helpful. Now I hesitate to request JTAG and Schem info. Please request again this is not helpful but mandatory now.
↧