Hi Stephen, Just so I'm understanding you correctly, you aren't using the original device/hardware you were having issues with, or the original LaunchPad you were using to program it with either? Does this mean any MSP430G2553 you try to program is not working properly? As far as next steps for the original hardware, I think it's time to investigate whether this is a soldering issue. Is it possible for you to take one of the "carbon copy" working boards and replace the '430 on it with the one that is not being detected correctly? Then place the remaining '430 on the board that was having detection issues. Just swapping out the two MSP430G2553s. Then retry programming both boards. This way we can see if the issue follows the device, the board, or disappears in which case it was most likely a soldering issue. Best regards, Caleb Overbay
↧