Hi Nikolaos, I've confirmed that the MSP-EXP430G2 LaunchPad supports the MSP430G2231 device, but can you please make sure that this 14-pin device is plugged into the DIP socket correctly? Refer to Figure 2 in the LP User's Guide . Was your setup working with other devices? Can you please make sure that the jumpers on J3 are connected properly? I'm assuming you're using the on-board emulator. Refer to Table 1 in the LP User's Guide . Which IDE are you using? IAR or CCS? Which version? Can you share any screenshots? Regards, James MSP Customer Applications
↧