Part Number: MSP432P401R Hi guys!!! I recently bought a msp432p401r launchpad rev2.0(red colored). It works at 3.3V natively. My question is can I supply 1.8V from external source to launchpad? Then the setup will be as follows: All jumpers of J101 will be connected to facilitate the debugging except the 3V3 one on which I will provide 1.8V externally. The external supply will be connected to the jumper pin of MCU side & not the XDS-110-ET side. My only concern is that JTAG still will be expecting MCU pins to be at 3V3 while they would now be at 1V8. Or jtag will work fine?? Please tell me about any other precautions that has be taken into account which I may have left. Regards, Prasad.
↧