Hi Shubhankar, How do you have P8.0 set in your code (or have you not been able to load code yet due to this issue)? If you remove the resistor does the issue stop? I'm thinking if your code (or whatever was previously loaded in the device from before) sets P8.0 to output high for example, then the resistor to GND could cause a lot of current since it is not very large - e.g. if you have 3.3V Vcc and a 165 Ohm resistor by Ohm's law that's 20mA of current, which is too much. Regards, Katie
↧