unlike jtag, BSL trashes RAM. Any chance you load the code, let it boot and wait a few seconds and then go back in to read a serial number etc? Do a flash memory dump of jtag written vs bsl written and compare. application that reads at TI-TXT may not doing it right?, I ended just making a memory dump from d000 to fffff as the firmware. and then bsl upload 128bytes a time and only skip a block of 0xff, a general TI-TXT file have many @address and did not want to deal with that. Are you erasing infoA by mistake? BSL versions V2.01 and higher support automatic clearing of the LOCKA bit protecting information flash memory. When the BSL is entered from a reset condition, LOCKA is cleared by the BSL to mass erase the flash, including information memory
↧