Hello TI community, Recently I have purchased the concerto based solar explorer kit online to help with a school project. During the past two weeks I have been trying to connect the board, using the quick start guide and the provided GUI, to a computer provided for the project. When following the guide, it mentions that upon opening the GUI, the board should connect to the controller. Both my collegue and myself have checked that everything leading up to connecting the board was followed word for word. The led in M5 upon posting the board will blink (executing the code), but when we attach the Ethernet cable to the computer and try to run the GUI, it will tell us that it is unable to connect. It also says we should make sure the target is ready to connect and then to retry the connection. We would like to know if there is anything we should try or what could do to figure out what we might be doing wrong. Any links to data sheets on the architecture or guides to configure the board, besides the provided quick starter guide, would be appreciated. We are both at a loss for what to do. Any help at this point would be greatly appreciated. If pictures of our board/configuration are needed, I will post them in a reply shortly when I return from class. Thank you, Mac Shaffer
↧